#CISCO ENABLE SSH V2 PASSWORD#
#CISCO ENABLE SSH V2 PC#

If you need more information about Telnet commands and options, from the config-line mode type вЂњ ?вЂњ, the question mark will display all telnet commands. Now you are remotely connected to router R1 and you can execute all router commands through a telnet command-line interface. Next type enableВ command and press enter, thenВ typeВ the router password. Type telnet 192.168.10.1 and press enter, then enter the telnet password. If it does not work, try to troubleshoot telnet errors.

#CISCO ENABLE SSH V2 PC#

Now from a client PC test the telnet connectivity and to ensure that it works fine or not yet. R1(config)#exit Testing Telnet Connectivity

#CISCO ENABLE SSH V2 PASSWORD#

But you must set the enable password for the router in order to control it remotely. OK, the Telnet services enabled successfully. The motd-banner forces a banner message to appear when logging in.The вЂњ exec-timeoutвЂќ command just sets the time-out limit on the line from the default to вЂњ 40вЂіВ minutes.The вЂњ logging synchronousвЂќ command stops any message output from splitting your typing.If you type вЂњ no loginвЂќ command, the telnet never authenticates for the password which is not a good practice in a real network environment. The вЂњ loginвЂќ command authenticate and ask you the password of telnet.The вЂњ passwordвЂќ command set the вЂњ Pass123вЂќ as a password for telnet.If you need more session simultaneously, you must type вЂњ line vty 0 10вЂњ. The вЂњ line vtyвЂќ command enable the telnet and the вЂњ 0вЂі is just let a single line or session to the router.R1(config-line)#motd banner $Admin Access Only$ R1>enableД®nter configuration commands, one per line. Go to router R1 console and configure telnet withВ вЂњ line vtyвЂќ command. The Lab is configured with DHCP server and all clients get an IP address from DHCP Server on Router. First of the first download the CCNA Lab to Enable Telnet and SSH on Cisco Router from Telnet and SSHВ Lab. To enable telnet on Cisco router, simply do it with вЂњ line vtyвЂќ command. However, we just going to enable telnet and ssh to test them for CCNA Certification exams. But itвЂ™s not the best way to the wide-area network. You can configure telnet on all Cisco switches and routers with the following step by step guides. The Telnet is an old and non-secure application protocol for remote control services.

This article is going to shows the CCNA students toВ configure and enable telnet and ssh on Cisco router and switches.

Cisco enable ssh v2